This product has been superseded by MAF CAL
MAF CAL – MAF Scaling/Calibration with MAF CAL
Easily calibrate a MAF sensor signal after changes to the intake system. Scale a MAF signal with MAF CAL.
Increase or decrease MAF sensor signal by +/-50% to optimise engine fuelling (Not compatible with frequency based MAF sensors. …
WHAT OTHER PARTS DO I NEED TO USE THE MOVICHIP MAF Manager?
-A wideband lambda sensor with a 0-5 volt signal output to connect to the AutoMAF (if you want to use the live automatic tuning option)
-An Android smartphone with Bluetooth (to run the MAF Manager Android App)
For all vehicles we recommend having a separate gauge to monitor the lambda sensor when you are driving.
MAF Manager IS SUPPLIED WITH WHAT?
-Control Unit which mounts in the engine bay
-Connector (use the dropdown to choose if want a pre-populated connector or if you want to build your own wiring loom)
-Android App
-Instruction Manual with Wiring Pin Out Guide for connector (Download from this page, click the “Manual” tab)
What Else Do I Need?
Cables to make your loom (if you selected “bare connector” option)
Crimping tool (if you selected the “bare connector” option)
Android device with Bluetooth connection
Knowledge of automotive wiring and relevant tools so you can wire the product to the vehicle
MAF Manager – What do I need to do to get the product up and running?
-Install the MoviChip MAF Manager Android App on your phone
-Make up your wiring loom using the pinout guide
-Connect the unit the car
-Turn on car’s ignition
-Form the setting menu on you Android device, pair your device with the MAF Manager
-Open MAF Manager app
-Set your load points
-Set your approximate MAF scaling values
If you want to use the auto tune feature continue below, if not you are done!
-Set your target AFR values
-Switch the auto tuning feature on
If you want to use the MAF lock feature
-Set your Max MAF signal
-Set the load point for fixed idle MAF signal output (if you only want to set the max MAF value set this value as 0)
-Set the fixed MAF output signal
For more information see the product manual.
Using a different MAF sensor from stock
The operating range of the new MAF sensor should be the same as the original sensor ie if the minimum voltage and maximum voltage of the original sensor then the new sensor should have the same minimum and maximum voltage.
Hypothetically this should be enough to use the MAF manager but we cannot guarantee that the MAF Manager will work with any replacement MAF sensor that is not the same as the original.
![](https://movichip.com/media/newcase1_top.jpg)
![](https://movichip.com/media/newcase1_frontclose_corner.jpg)