CamSwitch 3 was designed to activate camshafts on engines which use dual profile camshafts, specifically Nissan’s VVL/Honda VTEC
CamSwitch 3 will trigger any camshaft/s which are switched on or off with a 12 volt source which uses less than 3 amps.
A minimum of one 0-5v sensor
RPM signal 0-5v which occurs 1,2,3 or 4 times an engine revolution.
Android phone with Bluetooth
The Cam Switch 3 Bluetooth App
Knowledge of automotive wiring and mechanical systems.
Q. Do I have to trigger two camshafts?
A. No. If you just need to trigger one camshaft, just connect one camshaft!
Q. Can I use it to activate other things?
A. Sure but you need to familiarise yourself with the way the relays are activated and how they are deactivated. From an electrical point of view the maximum current draw for the relays in 3 amps per relay, 5 amps total. Download the instruction manual for more information.
Q. Do I need to connect my phone to the Cam Switch 3 every time I use the Cam Switch 3?
A. Absolutely not! Connecting to your phone is only for adjusting the trigger settings and to troubleshoot.
99.999% of the time the Cam Switch 3 is a fit and forget device. Wire it up, tune your engine to find the optimum settings and your done, no need to do anything with it until you want to change your settings.
Q. I only need to trigger the camshaft using RPM and one 5 volt sensor signal. Is that possible?
A. Absolutely. Set the trigger threshold for Sensor 2 to zero. If the sensor value for Sensor 2 is bouncing around unacceptably connect the Sensor 1 signal to Sensor 1 and Sensor 2 input on the Cam Switch unit.
-Camshaft 1 activation at 30% MAP sensor signal & over 5000 rpm & coolant temp sensor over 70% signal
-Camshaft 2 activation at 30% MAP sensor signal & over 5500 rpm & coolant temp sensor over 70% signal
-Delay timer set to 1 second
Deactivation for both camshafts will happen at the same time one second after MAP sensor signal drops below 30% MAP or RPM drops below 5000rpm.
Cam Switch 3 – Colours
There are two indicator bars at the top of the app. These bars expand when the relay is activated. The left bar is Relay 1/intake cam. The right bar is Relay 2/exhaust cam. The colour of the bars can be changed through the options menu. (See the instruction manual)
Cam Switch 3 – Names
Default names are Relay 1, Relay 2, Sensor 1 and Sensor 2. These names can be changed in the Options Menu.
Cam Switch 3 – Test Relays
You can test the activation of the cams without the engine running.
Enter the options menu and choose the “Test Relays” option. This will disable the activation of the camshafts in normal engine running (so don’t forget to close the “Test Relay” menu when your testing is complete).
If the colours of the buttons are not changing, click the “Read Sensors” button again.
Unit power 12-24 volts with 1 amp inline fuse (fuse not included)
2 x 5 volt sensor inputs
1 x 5 volt timing signal. 1,2,3 or 4 sparks per engine revolution
2 x 12 volt output with 5 amp inline fuse on positive (fuse not included). Permanent 12 volt to solenoid/motor, switch on negative side.\
2 x 5 volt output. For external sensors eg you want to use a MAP sensor but engine does not have one. 0.5 amp current draw maximum per sensor.